Sekonic MULTIMASTER L-408 Betriebsanleitung PDF herunterladen (Seite 23)

When the flash fires, the aperture value will appear on the LCD panel. The

cumulative exposure of each measurement and the number of flashes also

appear.

When a single flash firing is

measured

b‘

,-,-

’

iJ/J$‘-

,.e..r,.l*.*l.

1 1.4 2 2.8 4 5.6 8 11 162?324564d

When four flash firings are measured

(

*.,.,*,.,..*..,.,*

1 1.4 2 2.8 4 5.6 8 11 16 22 32 45 64 90

~3 To cancel Cumulative mode, just press the FEV/MULTI button. To restart

metering with new setup, press the F/EV/MULTI button.

NOTES

After this measurement, the

remains in standby mode.

mark continues to blink and your L-408

The standby mode continues for approximately 90 seconds.

8 If the flash is NOT metered by your L-408 (when the flash is dimmer

than the ambient light), use flash measurement with cord.

If the shutter speed is changed after measurement, the measurement is

lost and the exposure is cleared to zero (0).

l If a rapid start luminescent lamp or special illumination lamp light is to

be measured (although no flash fires), use flash measurement with

cord.

No flash bulb measurement is supported. Use the synchro cord

instead.

8.4 Contrast measurement

Contrast measurement is the same as for ambient light measurement (see Step 6.6 of

Page 13).

1 2 ... 18 19 20 21 22 23 24 25 26 27

Keine Kommentare

Sekonic MULTIMASTER L-408 Betriebsanleitung Seite 23