Sekonic SR-430 Spezifikationen PDF herunterladen (Seite 36)

-27-

9. Control Commands

This device operates according to command signals sent from the host computer. Control commands and

data are all sent and received in ASCII codes.

9-A Initialize Commands

The following commands are used to change the status of the device immediately after the power is

turned on:

-1 Kinds of Initialize Commands

9.Control Commands

-2 DLE DL Command (Reading Sensitivity Setting Command)

[Explanation]

This command is for setting the reading sensitivity level.

16 levels corresponding to density levels 1 to 16 can be set.

For example, a mark of density level 2 or more is read when "02" is set.

The setting of the rotary switch is enabled when the power is turned on while software is prioritized

when a DL command is used.

This setting is not stored after the power is turned off.

* This applies to when the CAN command is executed.

In the SR-307 compatible mode, the density levels are 1 to 8.

[Format]

DLE D L N1 N2 CR

(10H) (44H) (4CH) (0DH)

N1N2: 2-byte ASCII code

dnammoCtamroFnoitanalpxE

LDELD LD∼ .ytisnedgnidaerehtsteS

DD3CD DD∼

gnidaerehtniecnereffidehtsteS

.ytisned

T ELD T∼ .tamrofgnimitehtsteS

3CD

3CD∼

3CD L∼

tuptuoenil-51roenil-21ehtstceleS

ehtnidaerebotsenilehtseificepS

.edomSEroDE,AE,E

4CD4CD∼ .srehtodnasedocrotarapessteS

NACNAC RC.ecivedehtsteseR

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 75 76

Keine Kommentare

Sekonic SR-430 Spezifikationen Seite 36